The EP Greenhouse geared motor is a concise and lightweight reduction geared motor with a limit switch system that’s suitable for assembly of a locally available electric motor. The gearbox is used in manually-controlled or climate-managed ventilation and display systems in greenhouses. The quick and easy-to-install EP reducer is usually rainproof and windproof. The reducer has a high protection course (IP65) and can be used within an ambient temperature of 0-60 °C.
The low-noise gearbox for Greenhouse has a gearwheel transmission and a worm wheel transmission, which are integrated in an aluminum precision housing. The self-braking worm wheel tranny ensures that the drive shaft is definitely locked when the decrease geared motor is not running. The fully sealed reduction gearbox comes with an growth chamber with a diaphragm to keep the gear oil at a low pressure under all circumstances, even at high temps. Thanks to the use of an growth chamber, the geared motor can be installed in any position. There are no restrictions, because there is no dependence on a bleed connect. The sealed reduction geared motor keeps the gear essential oil of the gear driver in optimal condition for its entire operating lifetime. The gear driver is suitable for discontinuous use, working course s3-30%, with a maximum activation period of 25 minutes.
The Gear box reduction gear motor comes with an FT85 motor assembly flange, on to which a suitable IEC standard motor can certainly be installed (EN 50347).
The Gear box has a rotating limit switch system with operating switches and circuit breakers (NC contacts) for turning off at the end positions. The limit switch system is installed in an included chamber and is certainly 
enclosed by an impact-resistant plastic material cover. The limit change system is obtainable and easy to adjust. The limit change system’s maximum switching range can be 40 or 64 revolutions of the drive shaft. The cabling is connected in spring-clip connections. The gearbox has an IP68 M16 x 1.5 cable gland (5-9 mm cable) for the cable feed-through.
The geared motor for greenhouse includes 16 teeth 5/8”x3/8” sprockets, keys and fasteners. The accompanying chain couplings and assembly plates are available as accessories.
Maximum drive torque of 150 Nm or 450 Nm.
Rotational speeds of 3 or 5 rpm for a mains frequency of 50 Hz or 3.6 or 6 rpm for a mains frequency of 60 Hz in the event of software of 4-pole electric motor.
Protection class IP65.
May be used in ambient temperature ranges of 0-60°C.
Ideal for discontinuous use, operating class s3-30%, optimum activation time 25 minutes.
Equipped as standard with 16-tooth galvanised chain coupling 5/8″x3/8″.
FT85 motor assembly flange for installing IEC regular motor (EN 50347).
Maximum switching selection of limit switch system 40 or 64 revolutions of the drive shaft.
IP68 M16x1.5 cable gland for cable feedthrough (5-9 mm cable).