SMR Gearbox Set up
Satisfactory overall performance depends upon appropriate set up. lubrication and upkeep. as a result it is important that the directions from the installation and upkeep leaflet. provided with each and every gearbox. are followed carefully. a few of the critical elements of belt and torque-arm installation are listed below.
one. Install pulley on gearbox input shaft as near to your reducer attainable, and mount reducer on driven shaft as shut to bearing as useful. failure to carry out this will result in excess loads from the input shaft bearings and output bearings and could induce their premature failure.
2. Install motor and wedge belt drive using the belt pull at approximately 90° on the center line concerning driven and input shafts. this can allow tensioning of the wedge belt drive using the torque arm which should ideally be in stress. if output hub runs anti-clockwise. torque arm must be positioned the best.
three. lnstall torque-arm fulcrum on a rigid support to ensure that the torque-arm are going to be at around correct angles for the center line with the driven shaft along with the torque arm case bolt. be certain there is certainly sufficient get up from the turnbuckle for belt tension adjustment.
Continue to keep shut.
Bell drive could possibly be found in any effortless postion. in case the torque arm is usually to be employed to tighten the belts, the drive should be at about tight angle on the line between the input and output shafts.
Bell drive could be positioned towards the appropriate if preferred.
If output hub rotates clock-wise. position belt drive and torque arm in opposite course to that proven while in the illustration.
Torque arm and belt consider up.
Torque arm may very well be mounted on the correct if wanted.